/ / / Appearance

  • E46 DSC Disable Module

    $80.00

    This module will automatically disable the MK60 DSC each time you start the car.

    It plugs into the back of the switch panel on the console, while maintaining the console (including the DSC button) functionality, illumination, etc. It easily tucks behind the dash in a street car or can be zip-tied out of the way in a race car.

    It waits for 10 seconds after the ignition is switched on before turning the DSC off, then goes into hibernation until the ignition is cycled again. The car can be started immediately or you can pause before starting the engine and wait for the DSC to be disabled.

    Please refer to the following document for installation instructions and further discussion on why this method is preferable over disabling the Yaw sensor.

    Installation Instructions

    The Information Repository contains further information regarding the operation of the MK60 system.

    Add to cart Done

  • E46 Touring Roof Rail Delete Kit

    $35.00

    3d Printed kit to patch the holes left in the drip rails when removing the roof-rack rails on an E46 touring.

    The community asked for a solution to the $800+ euro roof rail trim. This is a result of that request.

    This kit consists of 16 pieces and is enough to complete a single car.

    Each side has 4 penetrations that must be patched.

    Clip: Qty 6 per car. Used for the front large, front small, and middle holes
    Rear X-clip: Qty 2 per car. Used for the rear hole to support the rear cover. Left and Right are bespoke.
    Large Cover: Qty 4 per car. Used for the front large and middle holes.
    Small Cover: Qty 2 per car. Used for the front small holes.
    Rear Cover: Qty 2 per car. Used for the rear holes only. Marked “R”.

    October 2022 Update: Print Material switched from PETG to ASA for higher tolerance to temperature. If you ordered a kit prior to Sep 2022 and experience shrinkage, please contact me.

    Installation Instructions

    Add to cart Done

  • E46 Light Control Module (LCM / LSZ) Extension Cable

    $15.00

    10-Pin ribbon cable that allows you to reinstall the front panel of the factory E46 light switch to the dash after relocating the rear portion of the light switch.

    Usually necessary when roll cage dash bar interferes with the rear portion of the light module.

    Pre-Terminated – standard length is 12″, different lengths available upon request

    3d Printed bracket available separately

    Add to cart Done

  • E46 Light Control Module (LCM / LSZ) Relocation Bracket

    $10.00

    3d Printed bracket that allows you to reinstall the front panel of the factory E46 light switch to the dash after relocating the rear portion of the light switch.

    Usually necessary when roll cage dash bar interferes with the rear portion of the light module.

    Made from ASA, will not warp when left in a hot race-car on grid.

    Extension Cable available separately

    Add to cart Done